Standard tool with basic injector. Three arms for all positions. art. GL201	Special tool with basic injector, vertical (see above) and large pit injector (see below). art. GL202

Competitive systems use the technique of screw-injection, screwing makes you lose a lot of expensive resin. TGI invented the unique injection-system, this system injects under big pressure resin into the damage with minimal use of resin and with maximum result. The result will pleasantly surprise you.

Thanks to this unique, patented technology u can make a professional and almost invisible repair in some easy steps:

Only 7 steps:

1. Apply glass cleaner to the Power-vacuum base. Clamp the tool on the glass with the cylinder near the damage. If plenty is applied, the tool can slide sideways over the glass surface to inspect the damage during the repair.

2. Place the injector above the damage and screw the cylinder against the glass surface.

3. Fill the injector with 3 -4 drops of resin.

4. Put the piston in the injector and place the pressure plate. Wait for 5 minutes, during this inspect from the inside of the car how the resin is filling the damage. Some heating may be off help to spread the resin more easily.

5. If the damage is nicely filled, remove the injector and place the plastic film on top of the damage.

6. Place the UV-light for 4 minutes (no need when enough sunlight is there).

7. At the end polishing can be done for a professional result.

Based on 17 years of experience our manual was written. It’s all about the different kinds of damages you can encounter and all about fixing these damages professionally.